|
Dispersor-X spreader wad 12ga(250/bag)
The original Dispersor-X is ideal for close-range shots of 5-25 yards. The integrated X-shaped spreader device molded directly into the shotcup provides shooters with even pellet distribution. Its G-type crush section reduces felt recoil in the 12-gauge while allowing a variety of load height adjustments. The pegged dome gas seal effectively distributes fast burn rate powders. Use of an overshot card (we like the #COS12 Clear Overshot Disc) helps create a bit of compression which will produce an even pattern distribution.
Identifying features: The DX12 dimensions are nearly identical to those of the DX12S with one important difference. Note the 24 pins that protrude down from the gas seal in two circular designs around one central pin. The obturator pins occupy space that would otherwise be filled with propellant, thus lifting the DX12S wad higher above the propellant charge. This change results in approximately a 1/4" increase in wad height in the hull. Use the DX12 for heavier shot drops and bulkier propellants
|
Curmudgeon's Loading Tip: If you are using a MEC reloader, their Steel Shot Rammer Tube #1308436 fits perfectly around the X-shaped spreader of the Dispersor-X 12ga wad. Very slick loading!
