Our Super Crown Crimp Starter is legendary. We've been making the finest crimp starter in the business for over 35 years. It is the ultimate crimp accessory for your MEC reloader and it solves the problem of getting a good, deep crimp start on new hulls.
Why brass? Machined from solid brass, the Super Crown's sharp edges make a deep impression in the hull's crimp folds. Yes, solid brass is an expensive material, but we use brass because that is what commercial loading machines use to create those reliable, deeply-folded crimps. Even unskived and new plastic hulls are easily creased for proper crimps once they go through any MEC crimp starter station equipped with the Super Crown. Easy to install and fits all MEC machines. Comes complete with wingnut hardware and crimp accommodation spring.
We machine these quality tools right here in Minnesota.
Super Crown crimp starters are available in four variations:
Crimping tips:
Six-point crimps are mainly used for larger pellets/hunting loads. 10 gauge and 12 gauge 3-1/2" and 3" are almost always six-point crimps. Because there are less folds involved with a 6-point crimp, it is generally easier to crimp hulls with in this manner
Eight-point crimps are generally for smaller pellets, which is why you always see target loads with 8-point crimps. The Super Crown produces deep and crisp edges, which will aid in closing up gaps. This tool helps to produce tighter, more consistent crimps.
Too sharp? It's possible to cut some types of hull materials, but this is rare. Remember, we manufacture the Super Crown with a sharp edge because that's what puts a deep memory in the crimp. It's easy to dull the edges a bit with a little emery cloth or fine-grit sandpaper. Just be careful when you are doing this.
Also Recommended:
- Advantages Manual
- MEC Reloaders
- Longer Set Screw (#0675336 necessary adaptor for all MEC progressive loaders)
Installation Notes: Remove stock plastic crimp starter and mounting bolt. Install Super Crown and adjust depth with locking nuts until proper height is achieved. Make sure that the Super Crown can rotate freely in the machine so that the points self-align with the existing crimp.
